You should learn the basics on how to install tiles, as well as the materials that you should prepare for this project. Whether you plan to install tiles in the bathroom, the garage, and other parts of the house, you should follow important instructions in the installation process. You can come up with the best results when you consider these shower tile ideas in installing great quality tiles.
What To Prepare Before and During Installation
Before you start working, you should know how to install tiles by preparing the right tools and equipment. The following items are necessary during the installation process.
- Cement backer board
- Sponges and rags
- Knee pads
- Grout (should complement the color of your tiles)
- Tile nippers, cutter, and tile saw
- Rubber float
- Tape measure
- Chalk line for determining the right position for the tiles
- Porcelain or ceramic tile
- Goggles or eye protection
- Notched trowel
- Hammer and nails
Detailed Instructions About The Basics
When you want to have the ease in installing floor tiles, try to follow these guidelines on how to install tiles the proper way.
- Remove all the moldings and baseboards, as well as the existing covering on your wooden floor.
- Keep the floor stable, and make sure that it does not flex or bend. Floor tiles may be hard, yet these are also brittle and are likely to crack when the floor bends. If the floor bends when you walk over it, try to stabilize it before you install the tiles.
- You can stabilize the floor by adding nails in the subfloor. Add bridging between the floor joists to make it stable and sturdy.
- Install the cement backer board on the stabilized floor. You can fasten it by using the right glue before nailing the board into the joists. Use two-inch galvanized type of nails in fastening the board.
- Make sure that the doors can still be opened over the tiled floors. You can check this by putting a tile on top of a board and check if the door can open easily. If it does not open, you can trim the bottom portion of the door.
- Clean up the debris and dust before you install the tiles.
- Use a tape measure in determining the total width and length of the room, so you know the number of tiles you will use.
- You should dry-fit your floor by placing a row of tiles along the marked lines at the center of the room. Use spacers between the floor tiles, so there is enough room for the grout.
- Evaluate the layout, and make any adjustments when you are not satisfied with the appearance.
- Use a thinset or cement that will hold the tiles in place. You may use the notched trowel in spreading the thinset where you plan to lay the first few tiles. Install the tile into the cement and apply downward pressure.
- Start installing tiles at the center portion of the room before you work on the areas near the walls and edges. You may use a tile saw or cutter for cutting the tiles to the right size.
- Leave the tiles overnight to make sure that these are stable and set completely on the floor.
How To Install Tiles: Difference Of Installation Based On Location
When you install tiles in the garage, you need to make sure that the floor is free from oil and grease. The floor tiles will stick properly when the ground is clean, so you need to wipe the area with a rug before laying out the tiles. Moreover, you should opt for self-stick tiles, so you can remove the tiles easily when you plan to redesign the garage.
Shower tiles are installed in a similar process, as in any other part of the house. However, you need to apply waterproof caulking to seal the tiles on the floor and the walls. This component will prevent the tile from coming off after some time.
You can try to consult a specialist when you are unsure about the proper way on how to install tiles. When you plan to do the project on your own, you can follow these tips for an easy installation process.