What are the best practices in cleaning a pool filter? Just because they are used for cleaning, that doesn’t mean that it doesn’t need its own day in the washroom. Pool filters are very important for the overall state of every pool. Without these vital pool equipment, the pool itself is at the mercy of germs and bacteria that will go uncheck into the water. That is why it is very important to learn some basic and helpful steps on how to clean pool filters.

how to clean a cartridge type swimming pool filter

Basic Cleaning Steps

Cleaning pool filters, especially the Hayward pool filter, is not too difficult. Here are the basic steps;

  • Take the filter apart and remove it and then pressure wash the element housing.
  • Soak the element in a bucket of 1/2 part water and 1/2 part filter element cleaner for one hour.
  • Then take the filter element and soak it in a bucket of 1/2 part water and 1/2part of muriatic acid for 15 minutes to 1/2 an hour.
  • Clean all visible debris from the housing and replace the element. Common sense should be used and a thorough cleaning using water is the most important part.

How to clean pool filters is not to hard or a complicated task. The best way is to clean the filter well and use plenty of water.

How to Clean Pool Filters With Basic Household Cleaning Products.

Take out the filter and rinse in with plenty of water. Clean the housing and soak the element in some type of cleaning solution. A person can use regular household cleaning products such as bleach. Make sure to rinse the filter well after soaking it and then replace.

Wash out the housing as clean as possible and one can even use an air compressor to blow out the filter. Cleaning the filter should not be done too many times before purchasing a new one. However; one can save a lot of money by periodically cleaning their filter in this way to extend the life of the filter. Make sure that if an air compressor is used that one does not blow holes in the filter with extensive air pressure..

proper swimming pool cartridge

The Purpose of Soaking a Filter.

By soaking a filter in a good cleaning solution as those mentioned above will take out the ground dirt and free up the filter so it can perform to its maximum capacity. Flushing the filter with water after soaking it is essential. One can accomplish a lot by using water and soap. In the long run a filter needs to be replaced once it becomes so dirty that it cannot accomplish the purpose it is made for.

It is always better to have a new filter but a person can save a lot of money by using these cleaning techniques. Common sense should always guide a person as to how long they have been using the same filter and when they should purchase a new one. If a filter appears to look good and the water in the pool is well cleaned, then one should not have to spend extra money on a new filter.